What issues should be paid attention to in PCB pads?

Pad is a kind of hole, pad design should pay attention to the following matters.

1. Diameter and inner hole size of pad: De ghnáth ní lú ná 0.6mm poll istigh an eochaircheap, toisc nach bhfuil sé éasca a phróiseáil nuair a bhíonn an poll níos lú ná 0.6mm. De ghnáth, úsáidtear trastomhas an bhioráin miotail móide 0.2mm mar thrastomhas poll istigh an eochaircheap. Más é 0.5mm trastomhas bioráin miotail na frithsheasmhachta, is é 0.7mm trastomhas poll istigh an eochaircheap, agus braitheann trastomhas an eochaircheap ar thrastomhas an phoill istigh. Hole diameter/pad diameter is usually: 0.4/1.5; 0.5 / 1.5;0.6 / 2; 0.8 / 2.5; 1.0 / 3.0; 1.2 / 3.5; 1.6/4. When the diameter of the pad is 1.5 mm, in order to increase the stripping strength of the pad, the length of not less than 1.5 mm, the width of 1.5 mm long circular pad can be used, this kind of pad is most common in the pin pad of integrated circuit. For the diameter of pads beyond the scope of the above table, the following formula can be used to select: hole with diameter less than 0.4mm: D/ D = 1.5-3; Holes with diameters greater than 2rran: D/ D =1.5-2 (where: D is the diameter of pads and D is the diameter of inner holes)

2. The distance between the edge of the inner hole of the pad and the edge of the printed board should be greater than 1 mm, so as to avoid the defect of the pad during processing.

3. When the wire connected with the pad is relatively thin, the connection between the pad and the wire is designed into a droplet shape, which is not easy to peel the pad, and the wire and the pad is not easy to disconnect.

4. Adjacent pads to avoid into an acute Angle or large area of copper foil. An acute Angle will cause wave soldering difficulties, and there is a danger of bridging, large area of copper foil due to excessive heat dissipation will lead to difficult welding.