1. Mora biti vakuumsko zapakiran

2. The number of PCB plošča per stack is limited according to the size is too small

3. Specifikacije tesnosti vsakega sklada PE filmske prevleke in predpisi o širini robov

4. Specifikacije za PE film in zračni mehurček

5. Specifikacije teže kartona in drugo

6. Ali obstajajo kakšni posebni predpisi za puferiranje pred vstavljanjem plošče v škatlo?

7. Specifikacije stopnje odpornosti po tesnjenju

8. Teža posamezne škatle je omejena

Trenutno je domača vakuumska embalaža podobna, glavna razlika je le učinkovito delovno območje in stopnja avtomatizacije.

Varnostni ukrepi:

a. Podatki, ki morajo biti napisani izven škatle, kot so “peroralna pšenična glava”, številka materiala (P/N), različica, obdobje, količina, pomembne informacije itd. In besede Made in Taiwan (če je izvoz).

b. Priložite ustrezne certifikate kakovosti, kot so rezine, poročila o varljivosti, zapisi o preskusih in nekatera poročila o preskusih, ki jih zahtevajo različne stranke, in jih postavite na način, ki ga določi stranka. Embalaža ni vprašanje univerze. Če to počnete s srcem, boste prihranili veliko težav, ki se ne bi smele zgoditi.

The circuit board is no better than other products, and it cannot be in contact with air and water. First of all, the PCB board cannot be damaged by vacuum. A layer of bubble film must be placed on the side of the box when packing. The bubble film has better water absorption, which plays a very good role in preventing moisture. Of course, moisture-proof beads are also indispensable. Then sort them and place them on labels. After sealing, the box must be stored in a dry and ventilated place with partition walls and off the ground, and avoid sunlight. The temperature of the warehouse is best controlled at 23±3℃, 55±10%RH. Under such conditions, PCB boards with surface treatments such as immersion gold, electro-gold, spray tin, and silver plating can generally be stored for 6 months. 3 PCB boards with surface treatment such as tin sink and OSP can generally be stored.