How to improve PCB dry film problems?

With the rapid development of the electronics industry, PCB wiring is becoming more and more sophisticated. Most ዲስትሪከት manufacturers use dry film to complete the graphics transfer, and the use of dry film is becoming more and more popular. However, I still encounter many problems in the after-sales service process. Customers have many misunderstandings when using dry film, which is summarized here for reference.

ipcb

How to improve PCB dry film problems

1. There are holes in the dry film mask
Many customers believe that after a hole occurs, the temperature and pressure of the film should be increased to enhance its bonding force. In fact, this view is incorrect, because the solvent of the resist layer will evaporate excessively after the temperature and pressure are too high, which will cause dryness. The film becomes brittle and thinner, and the holes are easily broken during development. We must always maintain the toughness of the dry film. Therefore, after the holes appear, we can make improvements from the following points:

1. Reduce the temperature and pressure of the film

2. Improve drilling and piercing

3. Increase exposure energy

4. Reduce developing pressure

5. After sticking the film, the parking time should not be too long, so as not to cause the semi-fluid drug film in the corner to spread and thin under the action of pressure.

6. Do not stretch the dry film too tightly during the pasting process

Second, seepage plating occurs during dry film electroplating
The reason for the permeation is that the dry film and the copper clad board are not firmly bonded, so that the plating solution is deep, and the “negative phase” part of the coating becomes thicker. The permeation of most PCB manufacturers is caused by the following points:

1. Exposure energy is too high or low

Under ultraviolet light irradiation, the photoinitiator that has absorbed the light energy is decomposed into free radicals to initiate a photopolymerization reaction to form a body-shaped molecule that is insoluble in a dilute alkali solution. When the exposure is insufficient, due to incomplete polymerization, the film swells and becomes soft during the development process, resulting in unclear lines or even film peeling, resulting in poor bonding between the film and copper; if the exposure is overexposed, it will cause development difficulties and also during the electroplating process. Warping and peeling occurred during the process, forming penetration plating. Therefore, it is very important to control the exposure energy.

2. The film temperature is too high or low

If the film temperature is too low, the resist film cannot be sufficiently softened and flowed properly, resulting in poor adhesion between the dry film and the surface of the copper clad laminate; if the temperature is too high, the solvent and other volatility in the resist The rapid volatilization of the substance produces bubbles, and the dry film becomes brittle, causing warping and peeling during electroplating electric shock, resulting in infiltration.

3. The film pressure is too high or low

When the film pressure is too low, it may cause uneven film surface or gaps between the dry film and the copper plate and fail to meet the requirements of the bonding force; if the film pressure is too high, the solvent and volatile components of the resist layer will volatilize too much, causing The dry film becomes brittle and will be lifted and peeled after electroplating electric shock.